Results 1 to 10 of 129
-
20th June 2014, 06:39 PM #1
SE 9.702 TRUCK NAVCORES for other devices
Pack Navcore 9.702 Universal SE by TonyZeta
A grande richiesta Internazionale:
PW--> Mark
Thanks to TonyZeta
Original .cab is here:-mark cat Reviewed by mark cat on . SE 9.702 TRUCK NAVCORES for other devices Pack Navcore 9.702 Universal SE by TonyZeta http://i.imgur.com/1euKHjN.png A grande richiesta Internazionale: Pack_SE_TZ_9.702_Uni (http://uploaded.net/file/aw4wmpax) PW--> Mark Rating: 5
-
The Following 23 Users Say Thank You to mark cat For This Useful Post:
- [ Click To Expand ]
-
aal50 (6th May 2016), angelig (15th December 2018), Anto002 (16th December 2019), axtrox (19th April 2015),
bajke(23rd April 2018), biggerdave (20th June 2014), chickenlicker22 (30th June 2018), daniele57 (20th June 2014), dkfranz (23rd May 2016), dudikov (8th October 2018), etesia (29th November 2014), kaode (21st June 2014), mace10001 (25th February 2018), mob_tom (12th December 2014), moki71 (25th March 2015), neyko68 (4th February 2018),Obol(29th May 2015), Peddersgolf (20th June 2014), Pesado (27th November 2017), salva_1964 (13th July 2019), torete62 (11th June 2015), vtv200 (15th January 2015), yuriyggg (20th June 2014)
-
20th June 2014, 08:07 PM #2
Installed this on my GO520.
I downloaded Pack_SE_TZ_9.702_Uni
Is anyone else have issue of unit freezing & rebooting after choosing any selection in the preferences section?
Anything i press on in preferences pages 1 to 7, will cause mine to freeze and then reboot.
Put 9.701 back in as was prior to installing 702 and all is well.
Best wishes
-
The Following 2 Users Say Thank You to Peddersgolf For This Useful Post:
- [ Click To Expand ]
-
-
20th June 2014, 08:57 PM #3
no , not so far ( using Yuri's version , but that should not matter normally )
did you patch it , cleared the flash and reset ?
you can try original version , that one should be clean to start with
-
The Following 1 Users Say Thank You to basflt For This Useful Post:
- [ Click To Expand ]
-
juan antonio (23rd May 2015)
-
21st June 2014, 01:27 AM #4
Thank you,
I wil have a go tomorrow,do a fresh install, clearing flash also, see if it cures it.
Best wishes
-
The Following 1 Users Say Thank You to Peddersgolf For This Useful Post:
- [ Click To Expand ]
-
juan antonio (23rd May 2015)
-
21st June 2014, 01:41 AM #5
ok
note that it has a bootloader
if you scared remove it before installing
it did not flash my device , but you never know
-
The Following 1 Users Say Thank You to basflt For This Useful Post:
- [ Click To Expand ]
-
juan antonio (23rd May 2015)
-
21st June 2014, 01:49 AM #6
Thanks for posting anything new in this or is it just different icons from 9.701 ???
-
The Following 2 Users Say Thank You to kaode For This Useful Post:
- [ Click To Expand ]
-
juan antonio (23rd May 2015), subires (31st May 2016)
-
21st June 2014, 01:57 AM #7
I thought i spotted it do a bootloader install as i wondered why the yellow bar that came on was soooo quick.
It doesn't seem to have done anything to the unit, as 701 and truck 930 map are running again.
-
The Following 1 Users Say Thank You to Peddersgolf For This Useful Post:
- [ Click To Expand ]
-
juan antonio (23rd May 2015)
-
21st June 2014, 06:05 PM #8
Trying to sort these out for my "SE" version post and I'm currently struggling with this for a 550 with Live traffic.
I just copied over/overwrote this new .cab onto my fully working 9.701 version and everything boots up/runs fine but although I'm connected to the ttserver, I cannot get/see the traffic bar on the right or any traffic info for a planned route etc. Same thing happens on a 940 (with no Live services)
Do we have a fix/alternative version for this?
So far this works fine on a 520 (so all x20's & x30's are OK) and I've still to check on an old One XL too
SPAM HUNTER/KILLER
Please do not just post "thanks" but use the "thanks" button bottom/right or the reputation star "*" bottom/leftS i m p l e s
-
21st June 2014, 06:46 PM #9
Back already!
Nope, certainly for my previous 9.701 SE version for x20/x30/x40/x50's I've never bothered wth emu/config etc and it's always run well (incl Traffic bar) so really don't want to go down the emu road if I can avoid it.
SPAM HUNTER/KILLER
Please do not just post "thanks" but use the "thanks" button bottom/right or the reputation star "*" bottom/leftS i m p l e s
-
21st June 2014, 10:34 PM #10
Seeing TonyZ made rev.1 of 9,702 (some improvements)
I wanted to try it on my ONE set as Car and emulation x40light,
with map Italy 930.5563, goes great, here's the pack:
Remember that if you use the GO to set it in x50 and delete the swap.
Note:
When used the swap in internal memory
formatted in FAT not FAT32
-
The Following 2 Users Say Thank You to mark cat For This Useful Post:
- [ Click To Expand ]
-
bajke(23rd April 2018), biggerdave (21st June 2014)
Garmin Topo France v6 Pro Entire...
Hello, as indicated by FireFox58 in his message...