Results 1 to 4 of 4
-
13th January 2020, 01:37 AM #1
What navcore for old tomtom one IQ routes? V3
Hello i was wondering what navcore to use for my old Tomtom one IQ routes.
I have tried several navcores.
The last one i have tried was 9.510 on bootloader 5.5279 with a 1040 map.
It worked ok when i ran it without gps receiption.
Then i shut my tomtom down and tried to start it up again.
But now tomtom boots up with the splash screen and then hangs and reboots.
I did not have to patch the navcore because it came from the navcore installer from this webpage.
I also tried to empty the tomtom and let tomtom home install the last navcore available and then patch it with
fastactivate (latest version).
The result was the same.
Is there someone who can help me out?
Help is appreciatedremmert Reviewed by remmert on . What navcore for old tomtom one IQ routes? V3 Hello i was wondering what navcore to use for my old Tomtom one IQ routes. I have tried several navcores. The last one i have tried was 9.510 on bootloader 5.5279 with a 1040 map. It worked ok when i ran it without gps receiption. Then i shut my tomtom down and tried to start it up again. But now tomtom boots up with the splash screen and then hangs and reboots. I did not have to patch the navcore because it came from the navcore installer from this webpage. I also tried to empty the Rating: 5
-
13th January 2020, 03:16 AM #2
I would go back to version 9.510 for 64mb devices.
You could try omitting mapsettings.cfg, which is usually the culprit when your TomTom ends up in a loop.
Depending on which GPS chip is in it, sirf star for example, but I see that there is a Broadcam in the One IQ route so there is no flash update possible, but check this with the first 2 characters of your serial number.
If your TomTom started well the first time with the same mapsettings.cfg then that is strange and the problem could also be something else.
I solve the satellite problem with my Rider v2 by having the QuickGSPFix run shortly before departure.
-
13th January 2020, 06:00 AM #3
@pe1agp: Rider v2 with SirfStar3?
-
13th January 2020, 02:03 PM #4
@Alfred_ML
NO, but I connect the Rider v2 with my pc and run QuickGSPFix.exe
Or use my own QuickGSPFix
City Navigator Europe NT 2025.10...
IMO I would get a 32GB SD card they are a few...